Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE
Bi-Fuel Models
| Aft-axle Tank Heat Shield Bolts | 55 Newton Meter (Nm) |
| Aft-axle Tank Fuel Supply Line Fitting | 30 Newton Meter (Nm) |
| Aft-axle Tank Remote Fuel Fill Line Fittings | 52 Newton Meter (Nm) |
| Aft-axle Tank Mounting Bolts | 115 Newton Meter (Nm) |
| LH Outboard Tank Fuel Supply Line Fitting | 52 Newton Meter (Nm) |
| LH Outboard Tank-to Shear Plate Nuts | 115 Newton Meter (Nm) |
| Side-addle Tank Mounting Bolts | 115 Newton Meter (Nm) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.