2000 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE

Compressor Clutch

A/C Clutch Air Gap 0.35-0.85 Millimeter (mm)
Cutch Plate Nut(Motorhome Chassis) 34-40 Newton Meter (Nm)
Compressor Clutch Hub Bolt 11-14 Newton Meter (Nm)
Air Gap Between Pulley and Hub 0.35-0.85 Millimeter (mm)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.