2000 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE

Oxygen Sensor: Service and Repair

EGO Sensor Wrench:

Factory service manual diagram





SPECIAL SERVICE TOOL(S)

REMOVAL
1. Disconnect the battery ground cable. For additional information, refer to Battery.


Factory service manual diagram





2. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.


Factory service manual diagram





3. Using the special tool, remove the HO2S.

NOTE: If removing the HO2S on a 6.8L engine, raise and support the vehicle. For additional information, refer to Maintenance/Service and Repair.

INSTALLATION
1. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.