Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE
Module Configuration
Manufacturer Options
NOTE:
^ If using the WDS, select Module Configuration and Programming, then follow the screen prompts.
^ Make sure module is listed as supporting manufacturer options and supports the specific item to be configured in the Module Configuration Index.
1. Select Service Bay Functions on the scan tool.
2. Select the module that contains the manufacturer options item to be programmed. Refer to the Module Configuration Index. Module Configuration Index
3. Select Manufacturer Options on the scan tool.
4. Select the vehicle.
5. Select the feature to be enabled or disabled.
6. Enable or disable the item as necessary.
NOTE:
^ If using the WDS, select Module Configuration and Programming, then follow the screen prompts.
^ Make sure module is listed as supporting manufacturer options and supports the specific item to be configured in the Module Configuration Index.
1. Select Service Bay Functions on the scan tool.
2. Select the module that contains the manufacturer options item to be programmed. Refer to the Module Configuration Index. Module Configuration Index
3. Select Manufacturer Options on the scan tool.
4. Select the vehicle.
5. Select the feature to be enabled or disabled.
6. Enable or disable the item as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.