Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999WINDSTAR BASE, VAN CARGO, 3.8 4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1857 (ENGINE COOLING SYSTEM (HYBRID))DIAGNOSIS AND TESTINGENGINE COOLINGDTC TABLEPCM DTC TABLE
1999 Ford Windstar Base, Van Cargo, 3.8 4
PCM DTC Table
1999 Ford Windstar Base, Van Cargo, 3.8 4SECTION PCM DTC Table
WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
PCM DTC TABLE
| DTC | Description | Action |
|---|---|---|
| P0125 | Insufficient Coolant Temp For Closed Loop Fuel Control | Go to PINPOINT TEST C . |
| P0128 | Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature) | Go to PINPOINT TEST C . |
| P0217 | Engine Coolant Overtemperature Condition | Go to PINPOINT TEST B . |
| P0480 P0481 P0482 |
Fan 1, 2 or 3 Control Circuit, Respectively | REFER to INTRODUCTION -- HYBRID . |
| P1285 | Cylinder Head Overtemperature Condition | Go to PINPOINT TEST B . |
| P1299 | Cylinder Head Overtemperature Protection Active | Go to PINPOINT TEST B . |
| All Other DTCs | - | REFER to INTRODUCTION -- HYBRID . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.