Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999WINDSTAR BASE, VAN CARGO, 3.8 4REPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 800 (MODULE CONFIGURATION)GENERAL PROCEDURESPROGRAMMABLE MODULE INSTALLATIONUSING THE VEHICLE COMMUNICATION MODULE (VCM) WHEN THE ORIGINAL MODULE IS AVAILABLE
1999 Ford Windstar Base, Van Cargo, 3.8 4
Using the Vehicle Communication Module (VCM) When the Original Module is Available
1999 Ford Windstar Base, Van Cargo, 3.8 4SECTION Using the Vehicle Communication Module (VCM) When the Original Module is Available
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- With the original module still installed, using the VCM and the latest version of the service function card, SELECT: Programmable Module Installation.
- Select the module being installed and press the trigger.
- Follow the on-screen instructions.
- SELECT: Retrieve Module Configuration - Old ECU. Press the trigger.
- Follow the on-screen instructions.
- INSTALL new module, SELECT: Restore Configuration - New ECU. Press the trigger.
- The VCM completes loading the retrieved data and displays Module Download Successful.
- Test the module for correct operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.