Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999WINDSTAR BASE, VAN CARGO, 3.8 4REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER WINDOWS SYSTEMPROGRAMMINGMODULE CONFIGURATION
1999 Ford Windstar Base, Van Cargo, 3.8 4
Module Configuration
1999 Ford Windstar Base, Van Cargo, 3.8 4SECTION Module Configuration
NOTE:
Powertrain Control Module (PCM) has to be flash programmed using a flash cable. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. The Integrated Circuit (IC) is reprogrammable, and at times it may become necessary to reprogram or reflash entire contents. This procedure can only be performed using Ford's Service Bay Technical System (SBTS) or equivalent.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.