SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999MUSTANG GT, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1904 (ENGINE CONTROLS - REFERENCE VALUES (EXCEPT DIESEL & HYBRID))3.5L 4V TAURUS/TAURUS X/SABLETYPICAL DIAGNOSTIC REFERENCE VALUES
1999 Ford Mustang GT, 2D Convertible, Standard

Typical Diagnostic Reference Values

1999 Ford Mustang GT, 2D Convertible, StandardSECTION Typical Diagnostic Reference Values
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
Sensors/Inputs PCM Pin/PID only Measured/PID Values Units Measured/PID
KOEO Hot Idle 48 KM/H (30 MPH) 89 KM/H (55 MPH)
PSP B17 LOW HIGH (I) LOW LOW HIGH/LOW
GENMON B23 0 46.09 22.66 25.78 %
APP1 B25 3.9 3.9 3.5 3.3 DCV
APP2 B26 1.6 1.7 1.8 2.1 DCV
APP3 B27 1.0 1.0 1.3 1.5 DCV
FPM B30 OFF ON ON ON ON/OFF
ACP_PRESS B37 1.34/103.98 1.34/103.98 0.89/47.99 0.93/51.98 DCV/PSI
MAF B41 0 0.7 1.4 1.5 DCV
IAT B43 2.1/105.8 (K) 2.1/105.8 (K) 3.9/32 (K) 3.9/32 (K) DCV/DEG F
FTP B44 2.6/-0.01 2.6/-0.01 2.6/-0.01 2.6/-0.01 DCV/PSI
BPA B47 OFF ON OFF OFF ON/OFF
O2S11_CUR (PZEV) E18 0 66 16 137 uA
O2S21_CUR (PZEV) E20 0 4 39 213 uA
O2S12 E23 0.87 0.33 0.78 0.6 DCV
O2S22 E24 0.16 0.21 0.8 0.6 DCV
CHT E41 0.74/179.6 0.71/181.4 3.86/183.2 3.81/188.6 DCV/DEG F
TP2 E60 1.1/25 0.8/15 1.0/19 1.4/27 DCV/%
TP1 E61 4.1/17 4.4/13 4.2/16 4.0/19 DCV/%
TSS T15 0 601.3 1130 1519 RPM
ACCS PID OFF ON OFF OFF ON/OFF
APP PID 0 0 16.5 17 %
B+ PID 12.06 14.06 14.5 14.25 DCV
BARO PID 149.6/13.26 149.6/13.26 149.6/13.26 149.6/13.26 Hz/PSI
BOO PID OFF ON (E) OFF OFF ON/OFF
CPP/PNP PID NEUTRAL NEUTRAL DRIVE DRIVE NEUTRAL/
DRIVE
DECHOKE PID NO NO NO NO YES/NO
EONV_RDY PID NOT READY NOT READY NOT READY NOT READY READY/NOT READY
EQ_RAT11 PID 0 (-)2-(+)2 (-)2-(+)2 (-)2-(+)2 RATIO
EQ_RAT21 PID 0 (-)2-(+)2 (-)2-(+)2 (-)2-(+)2 RATIO
ETC_ACT PID 7.37 2.95 4.68 23 DEG
ETC_DSD PID 7.62 2.98 4.74 23.19 DEG
ETC_TRIM PID -0.63 -0.61 -0.54 -0.54 DEG
FCIL PID OFF OFF OFF OFF ON/OFF
FLI PID 50 (H) 50 (H) 50 (H) 50 (H) %
GEAR PID 1 1 5 6 GEAR
INJPWR_M PID 0.34 13.97 14.19 14.14 DCV
LOAD PID 51.4 (L) 16.1 35.4 34.7 %
MIL_DIS PID 0 0 0 0 Miles
MISFIRE PID NO NO NO NO YES/NO
NM PID 0 0 0 0 COUNT
O2S11_
IMPED (PZEV)		 PID 4.94 1.0 0.93 0.97 DCV
O2S21_
IMPED (PZEV)		 PID 4.94 1.03 0.98 0.95 DCV
OSS PID 0 0 1131 1990 RPM
OSS_SRC PID 0 0 1121 2027 RPM
RPM PID 0 600 1200 1500 RPM
STRT_RLY PID ENABLED DISABLED DISABLED DISABLED ENABLED/
DISABLED
TCIL PID OFF OFF OFF OFF ON/OFF
TFT PID 176 176 192.2 192.2 DEG F
TFTV PID 0.8 0.81 0.63 0.62 DCV
TORQUE PID 207 4 18.7 45.42 Nm
TR PID P P OD OD MODE
TR2 PID OPEN OPEN CLOSED CLOSED OPEN/
CLOSED
TSS/ISS PID 0 600.8 1130 1516 RPM
TSS_SRC PID 0 600.3 1131 1516 RPM
VSS PID 0 0 30 55 MPH
Actuators/Outputs PCM Pin/PID only Measured/PID Values Units Measured/PID
KOEO Hot Idle 48 KM/H (30 MPH) 89 KM/H (55 MPH)
GENCMD B22 3.79 0 (Q) 0 (Q) 0 (Q) %
EVMV B50 0/OFF 0/OFF 543/
VARYING		 289/
VARYING		 mA/OFF-
VARYING
FP B62 OFF ON ON ON ON/OFF
HTR12 E1 OFF ON ON ON ON/OFF
HTRCM12 E1 609 609 566 566 mA
HTR22 E2 OFF ON ON ON ON/OFF
HTRCM22 E2 715 715 586 586 mA
PCVHC E33 0 0 0 0 %
VCTADV E67 0 -.031 -27.56 -30.94 DEG
VCTADV2 E68 0 0 -27.69 -31.06 DEG
O2S11_HTR (PZEV) E69 0 36.4 32.12 33.35 %
HTR11 (Non-PZEV) E69 ON (O) OFF ON ON ON/OFF
HTRCM11 E69 1.37 1.37 1.39 1.39 Amps
O2S21_HTR (PZEV) E70 0 39.5 28.29 25.48 %
HTR21 (Non PZEV) E70 ON (O) ON ON ON ON/OFF
HTRCM21 E70 1.35 1.35 1.35 1.35 Amps
CAT_EVAL PID YES YES YES YES YES/NO
CLRDIST PID 40.37 40.37 11.8 10.56 MILES
EGR_EVAL PID YES YES YES YES YES/NO
EVAP020C PID NO NO NO NO YES/NO
EVAP020D PID ALLOW ALLOW ALLOW ALLOW ALLOW/
DISALLOW
EVAP020R PID NOT READY NOT READY NOT READY NOT READY READY/NOT READY
EVAPCV PID 0/OFF 0/OFF 0/OFF 0/OFF %/ON-OFF
EVAPSOAK PID YES YES YES YES YES/NO
EVAPSTA PID 6-MONITOR COMPLETE 6-MONITOR COMPLETE 6-MONITOR COMPLETE 1-VAC STABLE STATUS
EVAP_EVAL PID YES YES YES NO YES/NO
FANDC PID 7.5 7.5 7.5 7.5 %
FANVAR PID 0 0 0 0 %
FTP_H20 PID -0.03 -0.03 -2.13 -3.38 in H2O
FUELSYST PID CLOSED LOOP CLOSED LOOP CLOSED LOOP CLOSED LOOP OPEN/
CLOSED LOOP
IGN_R/S PID ON ON ON ON ON/OFF
LONGFT1 PID (L) (-)20-(+)20 (-)20-(+)20 (-)20-(+)20 %
LONGFT2 PID (L) (-)20-(+)20 (-)20-(+)20 (-)20-(+)20 %
MIL PID OFF OFF OFF OFF ON/OFF
O2S_EVAL PID YES YES YES YES YES/NO
O2SHTR_
EVAL		 PID YES YES YES YES YES/NO
RPMDSD PID 1120 731.8 1179 608 RPM
SHRTFT1 PID (L) (-)10-(+)10 (-)10-(+)10 (-)10-(+)10 %
SHRTFT2 PID (L) (-)10-(+)10 (-)10-(+)10 (-)10-(+)10 %
SPARKADV PID 10 13.25 44 45.25 DEG
TRIP_CNT PID 1 1 0 0 COUNT
VCTADVERR PID 0 0.18 -0.37 -0.18 DEG
VCTADVERR2 PID 0 0.06 -0.43 0 DEG
VCTDC PID 0 0 47.32 80 %
VCTDC2 PID 0 0 46.8 80 %
VCTSYS PID OL CL CL CL OPEN/
CLOSED LOOP
Other PCM Pin/PID only Measured/PID Values Units Measured/PID
KOEO Hot Idle 48 KM/H (30 MPH) 89 KM/H (55 MPH)
VPWR B51/52/53 VBAT VBAT VBAT VBAT DCV
VREF C64 5 5 5 5 DCV
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.