SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999MUSTANG GT, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1904 (ENGINE CONTROLS - REFERENCE VALUES (EXCEPT DIESEL & HYBRID))2.3L 4V ESCAPE/MARINERTYPICAL DIAGNOSTIC REFERENCE VALUES
1999 Ford Mustang GT, 2D Convertible, Standard

Typical Diagnostic Reference Values

1999 Ford Mustang GT, 2D Convertible, StandardSECTION Typical Diagnostic Reference Values
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
Sensors/Inputs PCM Pin/PID only Measured/PID Values Units Measured/PID
KOEO Hot Idle 48 KM/H (30 MPH) 89 KM/H (55 MPH)
BOO B8 OFF ON (E) OFF OFF ON/OFF
FTP B9 2.6/0 2.6/0 2.5/-0.03 2.15/-0.12 DCV/PSI
FTP_H2O B9 -0.13 -0.13 -0.86 -3.27 in-Hg
ACCS B15 OFF ON (A) OFF OFF ON/OFF
IAT B20 111/1.96 (K) 104/2.16 (K) 3.15/66 (K) 3.18/64 (K) DCV/DEG F
TCS (A/T) B27 0.1/OFF VBAT/ON (G) 0.1/OFF 0.1/OFF DCV/ON-OFF
MAF (A/T) B32 0 0.9 1.4 2.5 DCV
MAF (M/T) B32 0 1-1.08 1-1.7 1.2-2.5 DCV
GENMON E16 0 37.5 15.63 15.63 %
TP E19 0.53-1.27 0.53-1.27 1-1.3 1.1-2 DCV
MAP E23 4/14.3 (W) 1.2/4.2 (W) 1.1/4.1 (W) 3.3/11.9 (W) DCV/PSI
FRT E28 2.5/93 (K) 2.6/90 (K) 3.1/72 (K) 3.1/72 (K) DCV/DEG F
O2S11 E30 (L) switching (C) switching (C) switching (C) DCV
CHT E33 3.4/210 3.4/212 3.4/212 3.2/225 DCV/DEG F
FRP E37 1.3/14 3.7/39 3.7/39 3.7/39 DCV/PSI
VSS (M/T) T3 0 0 30 55 MPH
OSS (A/T) T4 0 0 67-400 120/7300 RPM
TSS (A/T) T15 0 686 1547 1995 RPM
O2S12 T24 (L) (D) (D) (D) DCV
TRS (A/T) T27 4.4/PARK 4.4/PARK 2.1/OD 2.1/OD DCV/MODE
CPP (M/T) T27 0/ON 0/ON 12/OFF 12/OFF DCV/ON-OFF
TFT (A/T) T29 1.2/154 (K) 1.1/156 (K) 1.4/140 (K) 1.4/142 (K) DCV/DEG F
ACP PID OPEN (OK) OPEN (OK) OPEN (OK) OPEN (OK) OPEN/
CLOSED
B+ PID 13 14.3 14.19 14.19 DCV
BARO PID 157.7 157.7 157.7 155.8 Hz
CHT_COLD PID 80.6 75.2 82.4 80.6 DEG F
CHT_HOT PID 237.2 231.8 240.8 239 DEG F
CPP/PNP PID NEUTRAL NEUTRAL DRIVE DRIVE NEUTRAL/
DRIVE
EVMV PID 0 0 36 741 mA
FLI PID 50 (H) 50 (H) 50 (H) 50 (H) %
GEAR (A/T) PID 1 1 3 4 GEAR
HTRCM11 PID 1.46 1.46 1.53 1.53 Amps
HTRCM12 PID 750 750 852 852 mA
LOAD (A/T) PID 54 (L) 17.4 19.2 24.7 %
LOAD (M/T) PID (L) 10-20 19-30 30-48 %
MISFIRE PID NO NO NO NO YES/NO
RPM PID 0 680 1877 2252 RPM
PSP PID LOW HIGH (I) LOW LOW HIGH/LOW
TPCT PID 0.85 0.84 0.85 0.85 DCV
VSS PID 0 0 30 55 MPH
Actuators/Outputs PCM Pin/PID only Measured/PID Values Units Measured/PID
KOEO Hot Idle 48 KM/H (30 MPH) 89 KM/H (55 MPH)
FP B12 75 18 19.5 19.8 %
WAC/ACCR B25 VBAT/OFF 1.5/ON VBAT/OFF VBAT/OFF DCV/ON-OFF
EVMV B34 0 0-10/0-100 0-10/0-100 0-10/0-100 Hz/%
HFC B38 VBAT/OFF 0.1/ON (B) VBAT/OFF VBAT/OFF DCV/ON-OFF
LFC B39 VBAT/OFF VBAT/OFF VBAT/OFF VBAT/OFF DCV/ON-OFF
GENCMD E7 3.79 0 (Q) 0 (Q) 0 (Q) %
IAC E39 VBAT/6.89 10.1/37.37 8.2/60 (L) 7.6/64 (L) DCV/%
HTR11 E49 OFF 0.1/ON 0.1/ON 0.1/ON DCV/ON-OFF
EPC (A/T) T11 7.5/0 8.4/0 9-10/25-37 10.3-11.2/42-51 DCV/PSI
SSC (SS3) (A/T) T23 VBAT/OFF VBAT/OFF 8.8/OFF 8.8/OFF DCV/ON-OFF
SSA (SS1) (A/T) T42 VBAT/OFF VBAT/OFF VBAT/OFF 0.1/ON DCV/ON-OFF
SSB (SS2) (A/T) T43 0.1/ON (O) 0.1/ON VBAT/OFF VBAT/OFF DCV/ON-OFF
TCC (A/T) T46 VBAT/0 VBAT/0 VBAT/0 0.2/100 DCV/%
HTR12 T47 0.2/ON (O) 0.2/ON 0.2/ON 0.2/ON DCV/ON-OFF
CAT_EVAL PID NO NO NO NO YES/NO
EVAPCV PID OFF/0 OFF/0 OFF/0 (R) OFF/0 (R) ON-OFF/%
EVAPSOAK PID YES YES YES YES YES/NO
FAN PID OFF OFF OFF OFF ON/OFF
FCIL PID OFF OFF OFF OFF ON/OFF
FRP_DSD PID 39.15 39.15 39.15 39.15 PSI
FUELSYST PID OPEN LOOP CLOSED LOOP CLOSED LOOP CLOSED LOOP OPEN/
CLOSED LOOP
IMTV PID OFF ON ON ON ON/OFF
LONGFT1 PID (-)20-(+)20 (-)20-(+)20 (-)20-(+)20 (-)20-(+)20 %
MFC PID OFF OFF OFF OFF ON/OFF
MIL PID OFF OFF OFF OFF ON/OFF
PATSENABL PID ENABLED ENABLED ENABLED ENABLED ENABLED/
DISABLED
RPMDSD PID 848 672 672 672 RPM
SHRTFT1 PID (L) (-)10-(+)10 (-)10-(+)10 (-)10-(+)10 %
SPARKADV (A/T) PID 10 14-20 36-44 30-40 DEG
SPARKADV (M/T) PID 0 15 46 45 DEG
STRT_RLY PID ENABLED DISABLED DISABLED DISABLED ENABLED/
DISABLED
TCIL (A/T) PID OFF OFF OFF OFF ON/OFF
TPCT PID 0.85 0.84 0.85 0.85 DCV
TQ_CNTRL PID NONE NONE NONE NONE _
Other PCM Pin/PID only Measured/PID Values Units Measured/PID
KOEO Hot Idle 48 KM/H (30 MPH) 89 KM/H (55 MPH)
VPWR B35/36 VBAT VBAT VBAT VBAT DCV
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.