Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1999EXPLORER 4WD V6-4.0L VIN EREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRELECTRONIC CLIMATE CONTROL PANEL
1999 Ford Explorer 4WD V6-4.0L VIN E
Electronic Climate Control Panel
1999 Ford Explorer 4WD V6-4.0L VIN ESECTION Electronic Climate Control Panel
REMOVAL
1. Remove the radio chassis.
2. Remove the instrument panel finish panel.
1 Remove the screws.
2 Disengage the spring clips and remove the instrument panel finish panel.
3. Disconnect the connectors.
4. Remove the screws and remove the electronic automatic temperature control module.
5. Remove the electronic automatic temperature control module.
1 Disconnect the electrical connectors.
2 Remove the nuts.
3 Disconnect the vacuum hamess connector.
INSTALLATION
1. To install, reverse the removal procedure.
1. Remove the radio chassis.
2. Remove the instrument panel finish panel.
1 Remove the screws.
2 Disengage the spring clips and remove the instrument panel finish panel.
3. Disconnect the connectors.
4. Remove the screws and remove the electronic automatic temperature control module.
5. Remove the electronic automatic temperature control module.
1 Disconnect the electrical connectors.
2 Remove the nuts.
3 Disconnect the vacuum hamess connector.
INSTALLATION
1. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.