Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1998TAURUS V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER SWITCHSERVICE AND REPAIRWINDSHIELD WIPER SWITCH
1998 Ford Taurus V6-3.0L DOHC VIN S
Windshield Wiper Switch
1998 Ford Taurus V6-3.0L DOHC VIN SSECTION Windshield Wiper Switch
REMOVAL
1. Disconnect battery ground cable.
2. Tilt column to lowest position and remove key release lever.
3. Remove ignition switch lock cylinder.
4. Remove shroud screws and remove upper steering column shroud and lower steering column shroud.
5. Remove two self-tapping TORX screws retaining multi-function switch to steering column tube casting. Disengage multi-function switch from casting.
6. Disconnect the two electrical connectors.
INSTALLATION
1. Install two electrical connectors to full engagement.
2. Align multi-function switch mounting holes with corresponding holes in the steering column tube casting. Install two self-tapping TORX screws making sure to start the TORX screws in the previously tapped holes. Tighten to 2 - 3 Nm (18 - 26 inch lbs.).
3. Install upper steering column shroud and lower steering column shroud with screws.
4. Install ignition switch lock cylinder.
5. Install key release lever.
6. Connect battery ground cable.
7. Check steering column tube and multi-function switch for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.