Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1998TAURUS V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSSTEERINGSTEERING SHAFT
1998 Ford Taurus V6-3.0L DOHC VIN S
Steering Shaft
1998 Ford Taurus V6-3.0L DOHC VIN SSECTION Steering Shaft
Input Shaft to Gear Bolt 41-51 Nm (31-37 ft. lbs.)
Input Shaft Coupling To Column Shaft 22-28 Nm (16-20 ft. lbs.)
Tube Boot Nuts 5-6 Nm (45-63 inch lbs.)
Input Shaft Coupling To Column Shaft 22-28 Nm (16-20 ft. lbs.)
Tube Boot Nuts 5-6 Nm (45-63 inch lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.