Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1998TAURUS V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - ACCESSORIES AND OPTIONAL EQUIPMENTALARM MODULESERVICE AND REPAIRLIFTGATE INTERFACE MODULE
1998 Ford Taurus V6-3.0L DOHC VIN S
Liftgate Interface Module
1998 Ford Taurus V6-3.0L DOHC VIN SSECTION Liftgate Interface Module
REMOVAL
1. Remove rear license plate housing and bracket.
2. Disconnect harness connector and liftgate disarm switch connector from liftgate interface module.
3. Remove liftgate interface module from rear license plate housing and bracket.
INSTALLATION
1. Follow removal procedure in reverse order.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.