Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997PROBE BASE, STANDARDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSCHARGING SYSTEM - GENERATORBENCH TESTINGSTATOR GROUND TEST
1997 Ford Probe Base, Standard
Stator Ground Test
1997 Ford Probe Base, StandardSECTION Stator Ground Test
- Inspect stator laminations closely for signs of overheating. A burnt spot usually indicates shorted stator windings. Remove stator from generator. Set ohmmeter to X1000 scale. Connect one ohmmeter probe to one stator lead. Connect other probe to stator core. Ohmmeter should indicate infinite ohms.
- If meter indicates any continuity, stator winding is shorted to core and must be replaced. Repeat test for each stator lead. DO NOT touch probes or stator leads, or an incorrect reading will result.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.