1997 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 18 (Supplemental Inflatable Restraint System): Identification

WARNING: This page is about a different car, the 1997 Mercury Grand Marquis, 1997 Lincoln Town Car, and 1997 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: To avoid injury from accidental air bag deployment, read and carefully follow all WARNINGS and SERVICE PRECAUTIONSΒ  .

Vehicle is equipped with driver-side and passenger-side air bags and are identified by a letter "L" in fourth position of Vehicle Identification Number (VIN). VIN is located on top of instrument panel, near lower left corner of windshield. VIN is also stamped on Vehicle Certification (VC) label, mounted on left front door pillar.

The words Supplemental Restraint System (SRS) are embossed on steering wheel center hub and/or on instrument panel above glove box. A label denoting that vehicle is equipped with air bags is affixed to driver-side sun visor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.