Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 18 (Supplemental Inflatable Restraint System)
WARNING: This page is about a different car, the 1997 Mercury Grand Marquis, 1997 Lincoln Town Car, and 1997 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Identification
- Description & Operation
- Service Precautions
- Disabling & Activating Air Bag System
- Post-Collision Inspection
- Adjustments
- Disposal Procedures
- Removal & Installation
- System Operation Check
- Wire Repair
- Diagnosis & Testing
- Diagnostic Tests
- On-Demand Self-Test
- Pinpoint Test A - System Disarm Failure Or Internal Diagnostic Monitor Fault
- Pinpoint Test B - No Communication With Diagnostic Monitor
- Pinpoint Test C - No Air Bag Indicator Or Inoperative Lamp Circuit Or No Ignition Voltage To Diagnostic Monitor
- Pinpoint Test D - Continuous Air Bag Indicator
- Pinpoint Test E - Rapid Continuous Flashing Of Air Bag Indicator
- DTC B1869 -- No Air Bag Indicator Or Inoperative Indicator Circuit Or No Ignition Voltage To Diagnostic Monitor
- DTC B1342 - Internal Microprocessor Fault
- DTC B1869 - No Air Bag Indicator Or Inoperative Indicator Circuit Or No Ignition Voltage To Diagnostic Monitor
- DTC B1867 - Low Battery Voltage
- DTC B1913 - Air Bag Circuit Short To Ground
- DTC B1914 - Impact Sensor Shorted To Ground
- DTC B1921 - Diagnostic Monitor Not Mounted To Vehicle Properly
- DTC B1922 - SAFING Sensor Shorted To Battery Voltage
- DTC 1923 - Memory Clear Circuit Improperly Grounded
- DTC B1924 - System Disarm Failure Or Internal Diagnostic Monitor Fault
- DTC B1932 - High Resistance Or Open In Driver-Side Air Bag Circuit
- DTC B1933 - High Resistance Or Open In Passenger-Side Air Bag Circuit
- DTC B1934 - Low Resistance Or Short In Driver-Side Air Bag Circuit
- DTC B1935 - Low Resistance Or Short In Passenger-Side Air Bag Circuit
- DTC B1941 - Right Impact Sensor Feed/Return Circuit Open
- DTC B1942 - Left Impact Sensor Feed/Return Circuit Open
- DTC B1944 - Right Impact Sensor Not Mounted To Vehicle Properly
- DTC 1945 - Left Impact Sensor Not Mounted To Vehicle Properly
- Torque Specifications
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
