Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997MUSTANG GT, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORSOLENOIDS & SOLENOID VALVES
1997 Ford Mustang GT, 2D Convertible, Standard
Solenoids & Solenoid Valves
1997 Ford Mustang GT, 2D Convertible, StandardSECTION Solenoids & Solenoid Valves
SOLENOIDS & SOLENOID VALVES
| Component | Component Location |
|---|---|
| Air Injection Reaction Bypass (AIRB) Solenoid | In right front fender, near foglight. |
| EGR Vacuum Regulator (EVR) Solenoid (3.8L) | On right rear of engine, rear of throttle body. See Figure. |
| EGR Vacuum Regulator (EVR) Solenoid (4.6L) | Inside right fender, above tire splash panel. See Figure. |
| Evaporative Emission (EVAP) Canister Purge Valve (3.8L) | In right rear of engine compartment, beside A/C accumulator. See Figure. |
| Evaporative Emission (EVAP) Canister Purge Valve (4.6L) | In right rear of engine compartment, beside A/C accumulator. See Figure. |
| Idle Air Control (IAC) Valve (3.8L) | On top rear of engine, above valve cover. See Figure. |
| Idle Air Control (IAC) Valve (4.6L) | On top right side of engine, forward of throttle body assembly. See Figure. |
| Shift Lock Actuator | On steering column, near ignition switch. See Figure. |
| Trunk Lid Release Solenoid | On center rear of trunk lid, on latch assembly. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.