Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997EXPLORER 4D UTILITY, 4.0 E, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 5 (ENGINE CONTROLS - TESTS W/CODES - 5.0L)DRIVE CYCLESVEHICLE PREPARATION FOR OBD-II OR MONITOR REPAIR VERIFICATION DRIVE CYCLE
1997 Ford Explorer 4D Utility, 4.0 E, 4WD
Vehicle Preparation For OBD-II Or Monitor Repair Verification Drive Cycle
1997 Ford Explorer 4D Utility, 4.0 E, 4WDSECTION Vehicle Preparation For OBD-II Or Monitor Repair Verification Drive Cycle
WARNING: This page is about a different variant/trim than selected.
NOTE:
Vehicles equipped with Power Take Off (PTO) must have this system disengaged before proceeding. Verify by viewing the PTO PID for OFF status.
- Attach a scan tool and access the ECT, FLI, IAT PIDs:
- Verify the IAT PID is between 50-100° F (10-38°C).
- Verify the FLI PID is between 15% and 85% (only available on EVAP running loss systems).
- Warm the vehicle until the ECT PID reaches a minimum of 130°F (54° C).
- Clear all DTC's with the scan tool by pressing clear with the key on engine off. P1000 will remain. Leave the key in the ON position (do not move ignition switch to OFF position), and start the vehicle.
- Access the ON-BOARD SYSTEM READINESS menu on the scan tool to view the status of the OBD-II monitors.
- Proceed with the OBD-II drive cycle or selected monitor repair verification drive cycle. Once started, the engine must not be turned off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.