Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Wiper/Washer Switch
Wiper/washer switch is incorporated into multifunction switch on steering column. Disconnect multifunction switch connector. Measure resistance between specified terminals. See FRONT WIPER/WASHER SWITCH TEST table. See Fig 1 . If resistance is not as specified, replace multifunction switch.
| Switch Position | Terminals No. 2 & 3 | Terminals No. 1 & 2 | ||||
|---|---|---|---|---|---|---|
| OFF | 47,6000 | 103,300 | ||||
| Interval (MIN) | 11,300 | 3300 | ||||
| Interval (MAX) | 11,300 | 103,300 | ||||
| LO | 4080 | 3300 | ||||
| HI | 0 | 3300 | ||||
| WASH | (2) | Less Than 5 | ||||
|
||||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.