Torque Specifications

1997 Ford Explorer 4D Utility, 4.0 E, 4WDSECTION Torque Specifications
WARNING: This page is about a different car, the 1996 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Fuel Supply Manifold Bolts 15-18 (20-24)
Lower Intake Manifold Bolts 15-18 (20-24)
Oxygen Sensor 30 (41)
Throttle Body-To-Manifold Bolts 10-12 (14-16)
Upper Intake Manifold Bolts 15-18 (20-24)
INCH Lbs. (N.m)Β 
Camshaft Position Sensor Bolts 22-31 (2.5-3.5)
Crankshaft Position Sensor Bolts 80-106 (9-12)
Fuel Pressure Regulator Bolts 71-97 (8-11)
Pressure Relief Valve Cap 4-6 (.5-.7)
Thermostat Housing Bolts 71-97 (8-11)
Throttle Position Sensor Screws 11-16 (1.2-1.8)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.