Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997EXPLORER 4D UTILITY, 4.0 E, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES - 4.0LADDITIONAL SYSTEM FUNCTIONSGENERIC OBD-II PARAMETER IDENTIFICATION (PID)
1997 Ford Explorer 4D Utility, 4.0 E, 4WD
Generic OBD-II Parameter Identification (PID)
1997 Ford Explorer 4D Utility, 4.0 E, 4WDSECTION Generic OBD-II Parameter Identification (PID)
Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tester using the following steps:
- Select vehicle and engine selection menu (optional). See Figure.
- Select year, engine, model and any additional information requested by scan tester (optional).
- Select GENERIC OBD-II OPTIONS. Press CONT button if monitors are not complete.
- Select PID/DATA MONITOR.
- Turn ignition on or start engine and allow to idle.
- Follow operating instructions from scan tester menu.
- Select PIDs and press START.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.