Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Checking ABS Warning Light Sequence
Turn ignition switch to ON position with engine off. ABS warning light should come on for 3 seconds, then go out. If ABS warning light operates as specified, go to ROAD TESTING VEHICLE. If ABS warning light comes on and stays on, go to RETRIEVING ABS TROUBLE CODES. If ABS warning light does not come on, go to ABS WARNING LIGHT DOES NOT LIGHT.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.