Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997CROWN VICTORIA POLICE INTERCEPTOR, 4.6 WREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODESQUICK TESTSERIES THROTTLE ASSEMBLY INSPECTION
1997 Ford Crown Victoria Police Interceptor, 4.6 W
Series Throttle Assembly Inspection
1997 Ford Crown Victoria Police Interceptor, 4.6 WSECTION Series Throttle Assembly Inspection
Turn ignition off. Remove air tube from series throttle assembly. Check throttle plate for binding. Repair or replace as necessary. If fault cannot be isolated, go to CIRCUIT TEST HT - TRACTION ASSIST (TA) SYSTEM , step 20).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.