SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997CONTOUR LX, 2.5 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 50 (REMOTE KEYLESS ENTRY SYSTEM)PROGRAMMINGTRANSMITTER BATTERIES
1997 Ford Contour LX, 2.5 L, Standard

Transmitter Batteries

1997 Ford Contour LX, 2.5 L, StandardSECTION Transmitter Batteries
WARNING: This page is about a different car, the 1997 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.

Remove back cover from transmitter. Carefully remove batteries. Using Gauge System Tester (021-00055), test each battery separately. Connect 300-ohm resistor between battery terminals. Measure voltage across battery terminals. Voltage should be 2.5-3.5 volts. If voltage is not as specified, replace battery.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.