Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997CONTOUR LX, 2.5 L, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - W/OUT TRACTION CONTROLDIAGNOSISTEST D: ABS INDICATOR LIGHT ON, NO CODES RETRIEVED
1997 Ford Contour LX, 2.5 L, Standard
Test D: Abs Indicator Light On, No Codes Retrieved
1997 Ford Contour LX, 2.5 L, StandardSECTION Test D: Abs Indicator Light On, No Codes Retrieved
- Turn ignition switch to RUN position. Observe ABS warning light. If ABS light stays on, go to next step. If ABS light turns off after about 10 seconds, fault may be intermittent. Road test vehicle and observe ABS warning light. If ABS light turns on and off during test drive, repair intermittent short in harness, and go to next step.
- Turn ignition switch to OFF position. Disconnect ABS control module 24-pin connector C129 (located below brake master cylinder). Turn ignition switch to RUN position. If ABS light is off, turn ignition switch to OFF position and go to next step. If ABS light is on, repair short to ground in Black/Red wire between instrument cluster and ABS control module. Reconnect all connectors and retest system.
- Inspect, clean and reconnect ABS control module connector C129. Turn ignition switch to RUN position. If ABS warning light comes on, replace HCU. If ABS warning light does not come on, system is operational. Clear DTCs and retest system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.