Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1997CONTOUR LX, 2.5 L, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORSOLENOIDS & SOLENOID VALVES
1997 Ford Contour LX, 2.5 L, Standard
Solenoids & Solenoid Valves
1997 Ford Contour LX, 2.5 L, StandardSECTION Solenoids & Solenoid Valves
SOLENOIDS & SOLENOID VALVES
| Component | Component Location |
|---|---|
| A/C Clutch Solenoid (2.0L) | In right front of engine compartment, on A/C compressor. See Figure . |
| A/C Clutch Solenoid (2.5L) | In right front of engine compartment, on A/C compressor. See Figure . |
| Exhaust Gas Recirculation Vacuum Regulator Solenoid (2.0L) | In center rear of engine compartment. See Figure . |
| Exhaust Gas Recirculation Vacuum Regulator Solenoid (2.5L) | In center rear of engine. See Figure . |
| Idle Air Control Valve (2.0L) | On upper rear of engine, on intake manifold. See Figure . |
| Idle Air Control Valve (2.5L) | Upper rear of engine. See Figure . |
| Vapor Management Valve (2.0L) | In right rear of engine compartment, near firewall. See Figure . |
| Vapor Management Valve (2.5L) | In right rear of engine compartment, near firewall. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.