Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Coast, Resume Or Off Function Inoperative
Unplug servo connector. Measure resistance between pins No. 5 and 6 of servo connector while depressing each function switch and rotating steering wheel. If all resistance readings are as specified, replace servo. See CONTROL SWITCH RESISTANCES TABLE.
| Button Depressed | Ohms |
|---|---|
| COAST | 115-125 |
| OFF | 0-4 |
| RESUME | 2090-2310 |
| SET/ACCEL | 645-715 |
If one or more (but not all) resistance readings are not as specified, replace control switch assembly. If all resistance readings are not as specified, check control switch circuit for open or short.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.