1997 Ford Contour Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System - W/Traction Control: Operation: Abs

ABS control module receives a wheel speed signal from each wheel sensor. When wheel lock-up is about to occur, the ABS control module activates solenoid valves to modulate hydraulic pressure to each wheel. A pump/motor assembly provides constant hydraulic pressure to the system. The ABS incorporates self-diagnostic capabilities.

The ABS and BRAKE warning lights alert vehicle operator of problems in braking system. Red BRAKE warning light monitors master cylinder fluid level and parking brake lever status. Amber ABS warning light alerts vehicle operator that ABS has been turned off due to malfunction in ABS system.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.