Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Continuous Memory Self-Test (Emission Related)
1996 Ford RV Cutaway 5.8 HSECTION Continuous Memory Self-Test (Emission Related)
WARNING: This page is about a different car, the 1996 Ford Econoline and 1996 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tester using the following steps:
- Select vehicle and engine selection menu (optional). See Figure.
- Select year, engine, model and any additional information requested by scan tester (optional).
- Select GENERIC OBD-II OPTIONS. Press CONT button if monitors are not complete.
- Select DIAGNOSTIC TROUBLE CODES.
- Turn ignition on.
- Follow operating instructions from scan tester menu.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.