Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Red Light Check
Turn ignition switch to START position. Red light should be on. If Red light is not on, go to TEST B under PRELIMINARY CHECK TESTS . Allow ignition switch to return to RUN position. Red light should turn off. If Red light does not turn off, check parking brake switch. Repair/replace switch as necessary. If Red light remains on and parking brake switch is functioning properly, go to TEST E under PRELIMINARY CHECK TESTS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.