Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSFORD1996RV CUTAWAY 5.8 HREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESISUZUSERVICE PRECAUTIONS
1996 Ford RV Cutaway 5.8 H
Service Precautions
1996 Ford RV Cutaway 5.8 HSECTION Service Precautions
These precautions should be observed when working with SRS systems:
- Disable SRS system before servicing any SRS system or steering column component. Failure to do this could result in accidental air bag deployment and possible personal injury. See DISABLING & ACTIVATING AIR BAG SYSTEMΒ .
- Wait about 2 minutes after disabling SRS system before servicing. System maintains SRS system voltage for about 2 minutes. Servicing SRS system before 2 minutes have passed may cause accidental air bag deployment and possible personal injury.
- After repairs, ensure AIR BAG indicator light is working properly and no system faults are indicated. See SYSTEM OPERATION CHECKΒ .
- Always wear safety glasses when servicing or handling an air bag.
- Inflator module must be stored in its original special container until used for service. It must be stored in a clean, dry place, away from sources of extreme heat, sparks or high electrical energy.
- When placing a live inflator module (air bag module) on a bench or other surface, always face air bag and trim cover up, away from surface. This will reduce motion of module if accidentally deployed.
- After deployment, air bag surface may contain deposits of sodium hydroxide, which can irritate skin. Always wear safety glasses, rubber gloves and long-sleeved shirt during clean-up, and wash hands using mild soap and water. Follow correct disposal procedures.
- At no time should any electrical source be allowed near inflator on back of inflator module.
- When carrying a live inflator module, trim cover should be pointed away from your body to minimize injury in case of accidental deployment.
- DO NOT probe a wire through insulator; this will damage wire and eventually cause failure due to corrosion.
- If SRS system is not fully functional for any reason, vehicle should not be driven until system is repaired. DO NOT remove bulbs, modules, sensors or other components or in any way disable system from operating normally. If SRS system is not functional, park vehicle until repairs can be made.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.