Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996PICKUP F250, 2D PICKUP, 4.9 Y, STANDARD, M5OD-R2REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - REARDIAGNOSISCOMPONENT LOCATIONS
1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2
Component Locations
1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2SECTION Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Control Module | Behind Glove Box |
| Diode/Resistor Element | Under Power Distribution Center |
| RABS Test Connector | Below Bottom Right Corner Of Glove Box |
| Speed Sensor | Threaded Into Front Of Differential Housing |
| RABS Valve Assembly | On Inboard Side Of Left Frame Side Rail, Toward Rear Of Engine Compartment |
| Sensor Test Connector | Under Hood, On Left Wheelwell |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.