Control Units

1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2SECTION Control Units
CONTROL UNITS

Component Component Location
ABS Control Module (Rear) Behind glove box. See Figure.
Air Bag Diagnostic Module Behind left side of dash. See Figure.
Daytime Running Lights (DRL) Module (4.9L) On left side of lower radiator support. See Figure.
Daytime Running Lights (DRL) Module (5.0L & 5.8L) On left side of lower radiator support. See Figure.
Daytime Running Lights (DRL) Module (7.3L DI Turbo Diesel) On left side of lower radiator support. See Figure.
Daytime Running Lights (DRL) Module (7.5L) On left side of lower radiator support. See Figure.
Electronic Shift Control Module Behind right kick panel.
Ignition Control Module (ICM) (4.9L) On left rear side of inner fender panel. See Figure.
Ignition Control Module (ICM) (5.0L & 5.8L) On left rear side of inner fender panel. See Figure.
Ignition Control Module (ICM) (7.5L) On left rear side of inner fender panel. See Figure.
Injection Pressure Regulator (IPR) (7.3L DI Turbo Diesel) Top center of engine. See Figure.
Injector Driver Module (IDM) (7.3L DI Turbo Diesel) In left side of engine compartment. See Figure.
Powertrain Control Module (PCM) (4.9L) On left side of firewall, left of main harness connectors. See Figure.
Powertrain Control Module (PCM) (5.0L & 5.8L) On left side of firewall, left of main harness connectors. See Figure.
Powertrain Control Module (PCM) (7.3L DI Turbo Diesel) On left side of firewall, left of main harness connectors. See Figure.
Powertrain Control Module (PCM) (7.5L) On left side of firewall, left of main harness connectors. See Figure.
Programmable Speedometer Odometer Module (PSOM) Behind left side of dash.
Remote Keyless Entry Module Behind left side of dash. See Figure.
Warning Chime Module Behind lower center of dash. See Figure.
Wiper Control Module Above right kick panel. See Figure.
4WABS Control Module (Bronco) In left front corner of engine compartment. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.