Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996PICKUP F250, 2D PICKUP, 4.9 Y, STANDARD, M5OD-R2REPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESDRIVE AXLE - FRONT (DANA IFS)REMOVAL & INSTALLATIONAXLE PIVOT BUSHINGINSTALLATION
1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2
Axle Pivot Bushing: Installation
1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2SECTION Installation
Place NEW pivot bushing into carrier housing. Using Receiver Cup (T78P-5638-A2), forcing screw and Bushing Replacer (T80T-6538-A2), install bushing. To complete installation, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.