Power Circuits

1996 Ford Mustang Cobra, 2D Convertible, StandardSECTION Power Circuits

Turn ignition off. Using a DVOM, check for battery voltage between ground and PCM terminal No. 55 (KAPWR). Turn ignition switch to START or RUN position. Check for battery voltage between ground and PCM connector terminals No. 71 and 97 (VPWR). If battery voltage is not present, power is not being supplied from EEC power relay. See CIRCUIT TEST B under CIRCUIT TESTS in appropriate G - TEST W/CODES article.

POWERTRAIN CONTROL MODULE LOCATION

Application Location
Aerostar, Crown Victoria, Bronco, Econoline, Grand Marquis, Pickup & Town Car Left Rear Corner Of Engine Compartment, Near Brake Booster
Continental Rear Center Of Engine Compartment Under Splash Cover
Contour & Mystique Right Rear Corner Of Engine Compartment, Behind Power Steering Reservoir
Cougar, Mustang & Thunderbird In Passenger Compartment, Behind Right Kick Panel
Escort & Tracer In Passenger Compartment, Below Center Of Instrument Panel
Explorer, Mountaineer, Ranger, Sable, Taurus & Windstar In Engine Compartment, Right Rear Side On Cowl
Mark VIII In Passenger Compartment, On Left Side Cowl Behind Instrument Panel
Fig 1: Identifying Powertrain Control Module 104-Pin Connector Terminals
G96E29185
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.