Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSFORD1996MUSTANG COBRA, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROLS - SENSOR RANGE CHARTS - 4.6LELECTRONIC ENGINE CONTROL (EEC)THROTTLE POSITION (TP) SENSOR

1996 Ford Mustang Cobra, 2D Convertible, Standard

Throttle Position (TP) Sensor

1996 Ford Mustang Cobra, 2D Convertible, StandardSECTION Throttle Position (TP) Sensor

TP SENSOR SPECIFICATIONS

Throttle Angle

⁽¹⁾⁽²⁾ Volts

0°

0.40

25°

1.30

50°

2.20

75°

3.10

100°

4.10

⁽¹⁾	Measure voltage between ground and Red wire at TP sensor connector.

⁽²⁾	Voltage may differ by as much as 15 percent.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.