One-Touch Down Feature Inoperative

1996 Ford Mustang Cobra, 2D Convertible, StandardSECTION One-Touch Down Feature Inoperative

  1. Power Supply To One-Touch Module Check

    Ensure normal power window operate properly. Remove driver's door trim panel. Access module located in driver's door. Turn ignition switch to RUN position. Check for battery voltage on Pink or Light Blue/Black wire at one-touch down module harness connector. If battery voltage exists, go to next step. If battery voltage does not exist, repair open in Pink or Light Blue/Black wire between instrument panel fuse block and one-touch down module.
  2. One-Touch Circuit Ground Check

    Measure resistance between Black wire at one-touch down module harness connector and ground. If resistance is 5 ohms or less, replace one-touch down module. If resistance is greater than 5 ohms, repair open in Black wire. Retest system.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.