Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996EXPLORER 4D UTILITY, 4.0 X, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPSUNROOF - MOON ROOFS - POWERSYSTEM TESTSPIN POINT TEST E: ROOF SLIDING PANEL DOES NOT OPEN OR CLOSEE8: CHECK MOON ROOF CONTROL SWITCH FOR OPEN
1996 Ford Explorer 4D Utility, 4.0 X, 4WD, Standard
E8: Check Moon Roof Control Switch For Open
1996 Ford Explorer 4D Utility, 4.0 X, 4WD, StandardSECTION E8: Check Moon Roof Control Switch For Open
- Gain access to sliding roof panel motor.
- Using test lamp, back probe (Red) wire. See Figure .
- Toggle roof sliding panel switch to the close position.
- Did test lamp illuminate? If yes, replace damaged sliding roof panel motor. Restore vehicle. Retest system. If no, service (Red) wire for open. Restore vehicle. Retest system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.