Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996CUTAWAY E350, 7.3 FREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES - 7.3L DIESEL - EEC-IVQUICK TESTRETRIEVE/CLEAR CONTINUOUS DTCS
1996 Ford Cutaway E350, 7.3 F
Retrieve/Clear Continuous DTCS
1996 Ford Cutaway E350, 7.3 FSECTION Retrieve/Clear Continuous DTCS
Turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:
- Select VEHICLE & ENGINE SELECTION menu.
- Select NEW VEHICLE, YEAR & MODEL.
- Select DIAGNOSTIC DATA LINK.
- Select PCM - POWERTRAIN CONTROL MODULE.
- Select DIAGNOSTIC TEST MODE.
- Select RETRIEVE/CLEAR CONTINUOUS DTCs.
- Turn ignition on.
- Follow operating instructions from scan tool menu.
- Record DTCs and perform appropriate pinpoint test. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION .
- Continuous Memory DTCs must be cleared after servicing EEC-IV system. See CLEARING DTCS under SELF-DIAGNOSTIC SYSTEM.
- After test, cycle ignition off before running other tests or driving vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.