Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996CROWN VICTORIA POLICE INTERCEPTOR, 4.6 9REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMBLEEDING BRAKE SYSTEMBLEEDING PROCEDUREBLEEDING SYSTEM USING NGS SCAN TOOL
1996 Ford Crown Victoria Police Interceptor, 4.6 9
Bleeding System Using NGS Scan Tool
1996 Ford Crown Victoria Police Interceptor, 4.6 9SECTION Bleeding System Using NGS Scan Tool
- This procedure is used to bleed the brake pressure control valve block. Connect New Generation Star (NGS) Scan Tool (077-00500) to Data Link Connector (DLC). Turn ignition on.
- Enter vehicle identification information. Choose DIAGNOSTIC DATA LINK from menu selection. Next, choose ABS MODULE, FUNCTION TEST and SERVICE BLEED. Follow scan tool instructions until SERVICE BLEED PROCEDURE COMPLETE message is displayed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.