Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996BRONCO 5.0 N, AUTOMATIC, E4ODREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION SERVICINGLUBRICATIONDRAINING & REFILLINGCD4E (CONTOUR, MYSTIQUE & PROBE)
1996 Ford Bronco 5.0 N, Automatic, E4OD
CD4E (Contour, Mystique & Probe)
1996 Ford Bronco 5.0 N, Automatic, E4ODSECTION CD4E (Contour, Mystique & Probe)
- Raise and support vehicle. Place drain pan under transaxle. Remove transaxle drain plug and drain fluid from transaxle. Install transaxle drain plug.
- Add 5 qts. (4.8L) ATF. Start engine and run at idle for 5 minutes. Shift transmission through all gears during 5 minute time period. Remove transaxle drain plug and drain fluid from transaxle.
- Install transaxle drain plug and tighten to specification. See TORQUE SPECIFICATIONS . Add 5 qts. (4.8L) ATF. Start engine and run through all gears. Check fluid and add as required.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.