Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996AEROSTAR 2WD V6-182 3.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSERVICE AND REPAIRWITHOUT SCAN TOOL
1996 Ford Aerostar 2WD V6-182 3.0L
Without Scan Tool
1996 Ford Aerostar 2WD V6-182 3.0LSECTION Without Scan Tool
Resetting Keep Alive Memory (KAM)
Disconnect the negative lead from the battery for a minimum of 5 minutes. Resetting KAM will clear learned values the Powertrain Control Module (PCM) has stored for adaptive systems such as idle and fuel.
After KAM has been reset, the vehicle may exhibit certain driveability concerns. It will be necessary to drive the vehicle to allow the PCM to relearn values for optimum driveability and performance.
How to Clear Keep Alive Memory (KAM)
The PCM stores information about vehicle operating conditions and uses this information to compensate for component tolerances. When an emission related component is replaced KAM may have to be cleared to erase the information stored by the PCM from the original component.
To clear KAM, disconnect the negative side of the battery for a minimum of 5 minutes.
Disconnect the negative lead from the battery for a minimum of 5 minutes. Resetting KAM will clear learned values the Powertrain Control Module (PCM) has stored for adaptive systems such as idle and fuel.
After KAM has been reset, the vehicle may exhibit certain driveability concerns. It will be necessary to drive the vehicle to allow the PCM to relearn values for optimum driveability and performance.
How to Clear Keep Alive Memory (KAM)
The PCM stores information about vehicle operating conditions and uses this information to compensate for component tolerances. When an emission related component is replaced KAM may have to be cleared to erase the information stored by the PCM from the original component.
To clear KAM, disconnect the negative side of the battery for a minimum of 5 minutes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.