Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994RANGER 2WD L4-140 2.3L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION CONTROL MODULEDESCRIPTION AND OPERATION
1994 Ford Ranger 2WD L4-140 2.3L SOHC
Ignition Control Module: Description and Operation
1994 Ford Ranger 2WD L4-140 2.3L SOHCSECTION Description and Operation
DESCRIPTION
The main function of the Ignition Control Module (ICM) is to switch between ignition coils and trigger the ignition coils to spark.
OPERATION
The ignition control module receives the Profile Ignition Pickup (PIP) and Cylinder Identification (CID) signals from the crankshaft position sensor, and the Spark Output (SPOUT) signal from the powertrain control module. During normal operation, PIP is passed on to the powertrain control module and provides base timing and rpm information. The CID signal provides the ICM with the information required to switch between the ignition coils for cylinders 1 and 4 and the ignition coils for cylinders 2 and 3. The SPOUT signal (from the contains the optimum spark timing and dwell time information. The spark angle is determined by the rising edge of the SPOUT signal because that is when coil current "turns off" and spark occurs. The dwell time is controlled or varied by varying the duty cycle (duration) of the SPOUT signal. Current flows in an ignition coil (dwell) when SPOUT is "low". This feature is called Computer Controlled Dwell (CCD). Therefore, with the proper inputs of PIP, CID and SPOUT the ICM turns the ignition coils on and off in the proper sequence for spark control.
The main function of the Ignition Control Module (ICM) is to switch between ignition coils and trigger the ignition coils to spark.
OPERATION
The ignition control module receives the Profile Ignition Pickup (PIP) and Cylinder Identification (CID) signals from the crankshaft position sensor, and the Spark Output (SPOUT) signal from the powertrain control module. During normal operation, PIP is passed on to the powertrain control module and provides base timing and rpm information. The CID signal provides the ICM with the information required to switch between the ignition coils for cylinders 1 and 4 and the ignition coils for cylinders 2 and 3. The SPOUT signal (from the contains the optimum spark timing and dwell time information. The spark angle is determined by the rising edge of the SPOUT signal because that is when coil current "turns off" and spark occurs. The dwell time is controlled or varied by varying the duty cycle (duration) of the SPOUT signal. Current flows in an ignition coil (dwell) when SPOUT is "low". This feature is called Computer Controlled Dwell (CCD). Therefore, with the proper inputs of PIP, CID and SPOUT the ICM turns the ignition coils on and off in the proper sequence for spark control.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.