Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994RANGER 2WD L4-140 2.3L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONPINPOINT TESTSKM - WOT A/C CUT-OFF (WAC) A/C DEMANDKM72 - CHECK ACD CIRCUIT TO PCM FOR SHORT TO GROUND
1994 Ford Ranger 2WD L4-140 2.3L SOHC
KM72 - Check ACD Circuit to PCM For Short to Ground
1994 Ford Ranger 2WD L4-140 2.3L SOHCSECTION KM72 - Check ACD Circuit to PCM For Short to Ground
- Key "OFF".
- Low Pressure (LP) switch disconnected.
- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.
- Measure resistance between PCM side of the LP switch vehicle harness connector and chassis ground.
- Is resistance greater than 10, 000 ohms?
Yes -- Replace PCM. Reconnect all components. Re-evaluate symptom.
No -- Service short to ground. Reconnect all components. Re-evaluate symptom.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.