Webbing Cannot Be Pulled From Retractor

1994 Ford F 150 2WD Pickup L6-300 4.9LSECTION Webbing Cannot Be Pulled From Retractor
1. From the fully stowed position, attempt to pull webbing out of the shoulder belt retractor.
2. If OK, withdraw lap belt webbing and buckle up while sitting in seat. Repeat five times to obtain proper operation. If not OK, replace the front safety belt.
3. Check the restraint system for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.