Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994BRONCO FULL SIZE V8-302 5.0LREPAIR AND DIAGNOSISCRUISE CONTROLSERVICE PRECAUTIONS
1994 Ford Bronco Full Size V8-302 5.0L
Cruise Control: Service Precautions
1994 Ford Bronco Full Size V8-302 5.0LSECTION Service Precautions
NOTE: Prior to disconnecting battery, record pre-set radio frequencies.
DISARMING
1. Disconnect battery negative, then positive cable.
2. Wait at least one minute for back-up power supply to deplete its stored energy.
3. Remove air bag module to steering wheel retaining nuts.
4. Disconnect driver side air bag module connector.
5. Connect Rotunda Air Bag Simulator 105-00010, or equivalent, to vehicle harness at top of steering wheel.
6. Connect battery cables.
ARMING
1. Disconnect battery negative, then positive cable. Wait one minute for back-up power supply to deplete stored energy.
2. Remove air bag simulator from vehicle harness connector at top of steering column.
3. Connect air bag module connector.
4. Install air bag module.
5. Connect battery cables.
NOTE: After the battery has been disconnected and reconnected, abnormal drive conditions may be present while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 10 or more miles to relearn the strategy.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.