Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994ASPIRE SE, AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESVOLKSWAGENSERVICE PRECAUTIONS
1994 Ford Aspire SE, Automatic
Service Precautions
1994 Ford Aspire SE, AutomaticSECTION Service Precautions
Observe these precautions when working with air bag systems:
- DO NOT use computer memory saver tool. Using computer memory tool will keep air bag system active and may cause accidental deployment of air bag unit.
- Disable air bag system before servicing any air bag system or steering column component. See DISABLING ACTIVATING AIR BAG SYSTEM .
- Because of critical operating requirements of system, DO NOT attempt to service any air bag system component.
- Air bag parts should not be left unattended. They should be installed in vehicle immediately after obtaining them.
- Air bag components which have been dropped more than 18 inches should not be used.
- Chemical cleaners, oil and grease should not contact vinyl covering on air bag unit.
- DO NOT place stickers or covers on steering wheel.
- Always disable air bag system before performing electric welding on vehicle.
- Air bag system can only be tested using Diagnostic Tester (VAG 1551). Never use test light on air bag system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.