Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994ASPIRE SE, AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESBMWDISABLING ACTIVATING AIR BAG SYSTEMDISABLING SYSTEM
1994 Ford Aspire SE, Automatic
Disabling System
1994 Ford Aspire SE, AutomaticSECTION Disabling System
- Before proceeding, see SERVICE PRECAUTIONS . Retrieve fault codes before disconnecting battery. Ensure ignition is off. Disconnect and shield negative battery cable. Wait at least 5 minutes for energy capacitor in SRS control unit to discharge.
- Remove steering column lower casing cover. See Figure. Remove Orange SRS connector from its holder on steering column. Disconnect Orange SRS connector. On vehicles with passenger-side air bag, remove glove box and disconnect both Orange SRS connectors from passenger-side air bag module. On all vehicles, system is now disabled.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.