Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ground Circuits
Turn ignition off. Connect BOB, leaving PCM disconnected. Measure resistance between each specified BOB pin and ground. See the PCM GROUND CIRCUIT RESISTANCE table below. Repair indicated PCM ground circuit if resistance is greater than 5 ohms.
| PCM Pin | BOB Pin | Wire Color | ||
|---|---|---|---|---|
| 1G (1) | 36 | Black | ||
| 2A | 39, 40, 44, 60 | Black/Orange | ||
| 2B | 20 | Black/Orange | ||
| 2C | 16 | Black/Orange | ||
|
||||
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.