Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mechanical Inspection: Compression
Check engine mechanical condition using a compression gauge, vacuum gauge or engine analyzer. If using engine analyzer, see engine analyzer manual for specific instructions. Compression pressures are considered within specifications if lowest reading cylinder is within 75 percent of highest reading cylinder. Minimum compression should be 128 psi (883 kPa). Maximum compression variation allowed between cylinders is 14 psi (97 kPa).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.